Practice Test Geeks(WCL) Welding Certification Los Angeles Practice Test
← All WCL Flashcard Decks

Safety Standards & Regulations Flashcards

7 cards from real WCL practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Safety Standards & Regulations flashcards as text

  1. In California, which agency issues the Welder Performance Qualification certification that is commonly required by Los Angeles area contractors?

    Answer: The certifying body specified by the applicable code (e.g., AWS, ASME) hired by the employer

    Welder qualification is conducted per the applicable construction or manufacturing code (AWS D1.1, ASME Section IX, etc.) by a qualified employer or third-party testing agency, not a single state agency.

  2. What does a 'lockout/tagout' (LOTO) procedure protect against when maintenance welding is performed on machinery?

    Answer: Unexpected energization or startup of equipment during maintenance

    LOTO procedures (OSHA 1910.147) ensure equipment cannot be accidentally energized while welders perform maintenance work.

  3. Which type of respirator is required when welding stainless steel due to the hexavalent chromium (Cr VI) in the fumes?

    Answer: A half-face air-purifying respirator with P100 and OV/P100 combination cartridges, or a supplied-air respirator

    Hexavalent chromium is a known carcinogen requiring P100 particulate filtration; supplied-air respirators may be needed at higher concentrations.

  4. According to OSHA's Hazard Communication Standard (HCS 2012), where must safety data sheets (SDS) for welding consumables be accessible to workers?

    Answer: In the work area or readily accessible to employees during their shift

    OSHA HCS 2012 requires SDS to be readily accessible to employees during their shifts in their work area.

  5. When using oxy-fuel cutting equipment, which condition indicates a flashback and requires immediate equipment shutdown?

    Answer: A squealing or hissing sound in the torch with flame burning back into the hoses

    A squealing sound with the flame retreating into the hoses indicates flashback, a dangerous condition requiring immediate gas shutoff.

  6. Under Cal/OSHA Title 8 Section 5155, what is the permissible exposure limit (PEL) for ozone—a byproduct of welding arcs—as an 8-hour TWA?

    Answer: 0.1 ppm

    Cal/OSHA sets the PEL for ozone at 0.1 ppm as an 8-hour time-weighted average, reflecting its toxicity to the respiratory system.

  7. A welder in Los Angeles is about to weld on structural steel in a building with active fire sprinklers. Per NFPA 51B, who must be notified and what must be done before hot work begins?

    Answer: The building owner and fire department must be notified, and sprinkler impairment procedures followed if sprinklers will be shut off

    NFPA 51B requires notification of the building owner and the fire department when sprinklers may be impaired, with proper impairment control procedures followed.