Telescoping Boom and Jib Configuration Flashcards
7 cards from real NCCCO practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Telescoping Boom and Jib Configuration flashcards as text
When a fixed jib is attached to a telescoping boom, what effect does it have on the crane's load chart values?
Answer: Load capacity decreases due to additional weight and increased radius
Attaching a fixed jib reduces the crane's rated capacity because the jib adds weight and extends the load radius, both of which reduce allowable lift capacity.
During telescoping boom extension, what is the primary purpose of the boom extend/retract sequencing procedure?
Answer: To ensure proper pin engagement and prevent boom section separation
Sequencing procedures ensure that locking pins properly engage each boom section before the next is extended, preventing uncontrolled separation.
A crane operator is working with a telescoping boom extended to 80% of maximum length with a luffing jib attached. Wind speed increases to 25 mph. What is the MOST critical concern?
Answer: The increased surface area of the jib creates greater wind-induced side loading
A luffing jib presents significant surface area to wind, and at elevated speeds this creates substantial side loading that can exceed crane stability limits.
What does 'fly jib offset angle' refer to in crane rigging terminology?
Answer: The angle between the jib centerline and the main boom centerline
The fly jib offset angle is the angular difference between the jib's centerline and the main boom centerline, typically measured in degrees such as 0°, 15°, or 30°.
When must an operator consult jib-specific load charts rather than the main boom load chart?
Answer: Whenever a jib of any type is rigged and used for lifting
Any time a jib is in use for lifting, the operator must use the jib-specific load charts because main boom charts do not account for jib geometry and ratings.
What is the function of the 'live mast' or 'A-frame' on a crane equipped with a luffing jib?
Answer: It provides the structural support and pivot point for raising and lowering the luffing jib
The live mast or A-frame provides the structural anchor and sheave path needed to control the luffing jib's angle via the luffing line.
Before retracting a telescoping boom that has been used for a lift, what should the operator verify first?
Answer: That the load has been set down and the hook block is unloaded
The load must be set down and the hook block must be unloaded before retracting the boom to prevent structural damage and loss of control.