Crane Type Identification and Applications 1 Flashcards

A luffing jib tower crane is specified instead of a hammerhead (flat-top) tower crane for a high-rise project in a dense urban core. What is the primary reason for this selection?

Answer: The luffing jib can raise and lower its jib angle to avoid overswinging adjacent structures and airspace restrictions

A luffing jib can be angled upward during slewing, preventing the jib tip from sweeping over neighboring buildings, property lines, or restricted airspace — a critical advantage on congested urban sites where a fixed horizontal jib would trespass into adjacent space.

Which crane type is specifically designed for pick-and-carry operations, featuring a low center of gravity, 360-degree rotation, and a compact deck that allows it to maneuver loads through tight indoor or plant environments?

Answer: Carry deck crane

The carry deck crane (also called a pick-and-carry crane) is purpose-built to lift a load and transport it short distances. Its low-profile deck, 360-degree rotating boom, and tight turning radius make it ideal for confined industrial or plant settings where other cranes cannot maneuver.

A lattice boom crane and a hydraulic telescopic boom crane are both capable of making the same rated lift at 60 feet of radius. Which is a key structural advantage of the lattice boom configuration at longer radii and heavier loads?

Answer: A lattice boom maintains greater strength-to-weight ratio at extended lengths, supporting higher capacities at long radii

Lattice booms achieve a high strength-to-weight ratio because the open truss structure distributes stress efficiently over its length. This allows lattice boom cranes to carry heavier loads at greater radii compared to hydraulic telescopic booms of similar length, which are heavier and lose capacity more rapidly as radius increases.

A floating crane (crane barge) is the preferred equipment choice for which of the following project scenarios?

Answer: Lifting and placing heavy structural components for an offshore platform or marine bridge pier where land-based access is impossible

Floating cranes are mounted on barges or vessels and are uniquely suited to marine environments — including offshore platform construction, bridge pier installation, and underwater salvage — where land-based cranes cannot reach or position themselves.

An overhead bridge crane differs from a gantry crane primarily in how it is supported. Which statement correctly describes this distinction?

Answer: An overhead bridge crane is supported by the building's own runway beams attached to the structure, while a gantry crane is supported by freestanding legs that run along ground-level rails

Overhead bridge cranes derive their support from elevated runway beams that are integrated into the building structure. Gantry cranes, by contrast, are self-supporting — their bridge spans between two legs that travel along ground-level rails, making them suitable for outdoor yards or facilities without adequate structural support overhead.

A self-erecting tower crane is most appropriately selected for which project type compared to a conventionally erected tower crane?

Answer: Small to medium residential or light commercial construction where fast setup, easy relocation, and lower mobilization cost outweigh the need for maximum height or capacity

Self-erecting tower cranes fold out and are ready for operation in a matter of hours without a large erection crew or mobile assist crane. This rapid mobilization and lower cost make them ideal for smaller residential or light commercial projects, though their height and capacity are limited compared to conventionally erected climbing tower cranes.