Boom Angle and Radius Calculations 1 Flashcards

A crane has a 120-foot boom set at a 60-degree angle. What is the approximate working radius from the center pin to the load?

Answer: 60 feet

Working radius equals boom length multiplied by the cosine of the boom angle. cos(60°) = 0.5, so 120 × 0.5 = 60 feet. As the angle increases toward vertical, the cosine decreases and the radius shrinks.

A 150-foot boom is set at a 70-degree angle. What is the approximate working radius?

Answer: 51 feet

Radius = boom length × cos(boom angle). cos(70°) ≈ 0.342, so 150 × 0.342 ≈ 51 feet. Even though the boom is long, the steep angle keeps the load close to the crane.

A crane operator needs to reduce the working radius without changing the boom length or repositioning the crane. What must the operator do?

Answer: Raise the boom angle

Raising the boom angle makes it more vertical, which reduces the horizontal distance (radius) from the center pin to the load. This is how operators fine-tune radius during a pick without moving the crane.

An operator is lifting at a 25-foot radius with an 80-foot boom. He needs to swing the load to a new pick point that requires a 35-foot radius. Before swinging, what must the operator verify?

Answer: That the load chart permits the rated capacity at the new 35-foot radius

Increasing the radius (by lowering boom angle or swinging over uneven terrain) changes the leverage on the crane. The operator must confirm the load chart's rated capacity at the new radius is equal to or greater than the weight being lifted.

With an 80-foot boom, an operator raises the boom angle from 60 degrees to 75 degrees. By approximately how many feet does the working radius decrease?

Answer: 19 feet

At 60°: radius = 80 × cos(60°) = 80 × 0.500 = 40 feet. At 75°: radius = 80 × cos(75°) = 80 × 0.259 ≈ 21 feet. The decrease is approximately 40 − 21 = 19 feet, showing how sensitive radius is to angle changes at steeper angles.