Practice Test GeeksIPC - International Plumbing Code Practice Test
← All IPC Flashcard Decks

Plumbing Fixtures and Fittings Flashcards

6 cards from real IPC practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 6 Plumbing Fixtures and Fittings flashcards as text

  1. A plumber is installing a new bathroom group. According to the IPC, what is the minimum required clearance from the centerline of a water closet to a side wall or partition?

    Answer: 15 inches

    IPC Section 405.3.1 specifies that the minimum distance from the center of a water closet to any side wall, partition, vanity, or other obstruction shall be not less than 15 inches. This ensures adequate space for access and use.

  2. Which of the following is a requirement for individual shower valves according to the IPC to protect against scalding?

    Answer: They must be of a balanced-pressure, thermostatic, or combination type.

    IPC Section 412.3 mandates that individual shower and tub-shower combination valves be of the balanced-pressure, thermostatic, or combination balanced-pressure/thermostatic type conforming to ASSE 1016/ASME A112.1016/CSA B125.16 or ASME A112.18.1/CSA B125.1. These valves are designed to automatically compensate for pressure and temperature fluctuations to prevent scalding. In-line thermostatic valves are specifically prohibited for this application.

  3. When installing a domestic dishwasher, the drainage hose is connected to the kitchen sink drain. To prevent backflow from the sink into the dishwasher, what does the IPC require?

    Answer: A high loop in the drain hose or an air gap fitting.

    IPC Section 409.3 requires a dishwasher drain to connect to a wye fitting between the sink trap and the tailpiece, or to the disposal. To prevent backflow, the drain must either rise to the underside of the counter (a high loop) or be connected through an approved air gap fitting installed on the countertop.

  4. A bidet is being installed in a residential bathroom. What is the maximum allowable water temperature for the bidet fitting, as specified by the IPC?

    Answer: 110°F (43°C)

    According to IPC Section 408.3, the discharge water temperature from a bidet fitting must be limited to a maximum of 110°F (43°C) by a water-temperature-limiting device. This is a safety measure to prevent scalding.

  5. The waste from a residential automatic clothes washer discharges into a standpipe. According to the IPC, the fixture drain for this standpipe must connect to a branch drain or stack of what minimum diameter?

    Answer: 3 inches

    IPC Section 406.2 states that while the standpipe and its trap can be 2 inches, the fixture drain for the automatic clothes washer must connect to a branch drain or stack that is a minimum of 3 inches in diameter. This is to handle the high-volume, sudsy discharge from the appliance.

  6. Which of the following plumbing fixtures is explicitly prohibited by the International Plumbing Code?

    Answer: Trough urinals.

    IPC Section 401.2 explicitly prohibits the installation of trough urinals. This is primarily due to sanitary concerns, as they are more difficult to clean and maintain than individual fixtures.