Practice Test Geeks(ICND1) Interconnecting Cisco Networking Devices Part 1 Practice Test
← All ICND1 Flashcard Decks

Routing Technologies & Protocols Flashcards

7 cards from real ICND1 practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Routing Technologies & Protocols flashcards as text

  1. Which EIGRP metric components are used by default?

    Answer: Bandwidth and delay

    By default, EIGRP uses only bandwidth and delay (K1 and K3) in its composite metric calculation.

  2. What is the maximum hop count supported by RIPv2?

    Answer: 15

    RIPv2 supports a maximum hop count of 15; a hop count of 16 is considered unreachable.

  3. Which command verifies the OSPF neighbor state on a Cisco router?

    Answer: show ip ospf neighbor

    The 'show ip ospf neighbor' command displays OSPF neighbor relationships and their current state.

  4. In OSPF, which router is elected as the Designated Router (DR) on a multi-access segment?

    Answer: The router with the highest router-ID and priority greater than 0

    The DR is elected based on the highest OSPF priority, with the router-ID as a tiebreaker; a priority of 0 disqualifies a router.

  5. A network administrator adds 'passive-interface GigabitEthernet0/1' under RIP. What is the effect?

    Answer: RIP updates are received but not sent on Gi0/1

    A passive interface suppresses RIP update transmission but still processes received updates and advertises the connected network.

  6. What type of routing protocol is OSPF classified as?

    Answer: Link-state

    OSPF is a link-state routing protocol that builds a complete topology map using LSAs flooded throughout the area.

  7. Which command displays the contents of the EIGRP topology table?

    Answer: show ip eigrp topology

    The 'show ip eigrp topology' command shows all EIGRP routes including successors and feasible successors.