FREE FCTC Test Verbal and Visual Information Questions and Answers

Question 1

Study the provided diagram of a fire hydrant. Which labeled component must be turned by a firefighter to open the main valve and permit water to flow into the hydrant barrel?

Accepted Answer

Operating Nut

Answer

Bonnet

Answer

Outlet Nozzle

Answer

Barrel

Question 2

Review the provided table, which shows the required pump discharge pressure (PDP) to achieve a desired nozzle pressure for different lengths of 1.75-inch hoseline. What is the correct PDP for a 250-foot hoselay to achieve a 100 PSI nozzle pressure?

Accepted Answer

185 PSI

Answer

155 PSI

Answer

170 PSI

Answer

200 PSI

Question 3

A fire is reported at the 'Office Building' on the corner of Oak Avenue and 2nd Street. Your engine is staged at the hydrant located at the corner of Main Street and 1st Street. Based on the provided map, what is the most direct route to the incident?

Accepted Answer

Proceed east on 1st Street, then turn north on 2nd Street.

Answer

Proceed north on Main Street, then turn east on Oak Avenue.

Answer

Proceed east on Oak Avenue from Main Street.

Answer

Proceed north on 2nd Street from 1st Street.

Question 4

Examine the bar chart, which displays the number of training hours completed by an engine company in four different subjects last month. Which of the following statements is an accurate conclusion based on the chart's data?

Accepted Answer

Driver Training accounted for exactly half the hours of Forcible Entry training.

Answer

The crew spent more time on EMS training than on all other subjects combined.

Answer

Forcible Entry and HazMat training combined for fewer hours than EMS training.

Answer

HazMat training was the subject with the highest number of training hours.

Question 5

Read the following procedure for cleaning a Self-Contained Breathing Apparatus (SCBA) facepiece: 'First, disconnect the regulator from the facepiece. Second, wash the facepiece with a mixture of warm water and approved mild soap. Third, rinse the facepiece thoroughly with clean water to remove all soap residue. Fourth, immerse the facepiece in an approved sanitizing solution for the manufacturer-specified time. Finally, allow the facepiece to air dry completely before returning it to service.' According to this procedure, what step is performed immediately after washing the facepiece with soap and water?

Accepted Answer

Rinsing the facepiece with clean water.

Answer

Allowing the facepiece to air dry.

Answer

Disconnecting the regulator.

Answer

Immersing the facepiece in sanitizer.

Question 6

A passage describes a 'flashover' as the near-simultaneous ignition of most of the directly exposed combustible material in an enclosed area. An accompanying diagram shows a room with a small fire in one corner (Stage 1), then the room filled with a thick layer of dark smoke at the ceiling (Stage 2), and finally the entire room engulfed in flames (Stage 3). Based on both the text and the diagram, what is the primary contributor to a flashover event?

Accepted Answer

The ignition of the hot gas layer that has accumulated at the ceiling.

Answer

The application of water from a hoseline.

Answer

The failure of the building's structural components.

Answer

The removal of all oxygen from the room.