Forklift certification Emergency Procedures Flashcards
7 cards from real Forklift certification Certification practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Forklift certification Emergency Procedures flashcards as text
Under OSHA regulations, within how many hours must an employer report a work-related fatality involving a forklift?
Answer: 8 hours
OSHA 29 CFR 1904.39 requires employers to report any work-related fatality to OSHA within 8 hours of the incident.
A forklift operator is accidentally splashed with battery acid while checking the battery. What is the correct first aid response?
Answer: Immediately flush the affected area with large amounts of water for at least 15–20 minutes
Flushing with large amounts of water for 15–20 minutes dilutes and removes the acid to prevent further chemical burns.
What should a forklift operator do if the mast becomes stuck in the raised position with a load?
Answer: Immediately lower the load using manual hydraulic release if available, block off the area, and call maintenance
A stuck mast with a raised load is a serious hazard; the area below must be immediately blocked, the manual hydraulic release used if available, and maintenance notified.
After a forklift is involved in a significant collision with a storage rack, what OSHA-required step must be completed before the rack is used again?
Answer: The rack must be inspected and cleared by a competent person or structural engineer
OSHA requires that racking damaged by a collision be inspected by a competent person — ideally a structural engineer — before being reloaded to prevent collapse.
An electric forklift catches fire due to an electrical fault. What type of fire extinguisher is appropriate?
Answer: Class C (dry chemical or CO2) extinguisher
Electrical fires require a Class C extinguisher (dry chemical or CO2) because water or Class A agents conduct electricity and can cause electrocution.
If a forklift's propane cylinder shows visible frost or ice around the valve during operation, what should the operator do?
Answer: Shut off the forklift, report the condition to maintenance, and do not attempt to use warm water
Frost on a propane valve indicates a pressure drop or leak; the operator must shut down and report it — never apply water or heat, as this can cause a dangerous pressure surge.
A forklift operator notices sparks coming from underneath the forklift near the battery compartment. What is the correct emergency response?
Answer: Immediately stop, lower the forks, shut off the forklift, evacuate the area, and activate the fire alarm
Sparks near the battery indicate an imminent fire or explosion risk; the operator must immediately shut down, clear the area, and activate emergency alarms.