Practice Test Geeks(F60) Certificate of Fitness for Fire Guard for Torch Operations Practice Test
← All F60 Flashcard Decks

Fire Guard Responsibilities Flashcards

7 cards from real F60 practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Fire Guard Responsibilities flashcards as text

  1. What is the minimum clearance radius that must be maintained between a torch flame and combustible materials?

    Answer: 10 feet

    A minimum 10-foot clearance radius must be maintained between the torch flame and all combustible materials.

  2. A fire guard is assigned to watch a roofing operation where tar is being applied with a torch. Which hazard requires special attention on a flat roof?

    Answer: Combustible roof insulation or membrane igniting

    On flat roofs, combustible insulation boards and roofing membranes are a primary ignition hazard that the fire guard must monitor closely.

  3. Before torch operations start in a building, what must the fire guard verify about fire suppression equipment?

    Answer: That at least one extinguisher and a charged hose line are available and operable

    The fire guard must confirm that at least one appropriate fire extinguisher and a charged hose line are available and in working condition before operations begin.

  4. During a fire watch after torch operations, the fire guard smells smoke but cannot see any visible flame. The correct action is:

    Answer: Immediately investigate the source and activate the fire alarm if a fire is found

    Any sign of smoke must be immediately investigated, and if a fire source is found, the alarm must be activated without delay.

  5. Which type of fire extinguisher is most appropriate for a fire guard to have on hand during torch operations involving flammable gases?

    Answer: Class B:C rated extinguisher

    A Class B:C rated extinguisher is appropriate for flammable gas and electrical hazards typically associated with torch operations.

  6. How must a fire guard document the completion of their fire watch duties?

    Answer: By completing a fire watch log recording the work performed, times, and observations

    The fire guard must complete a fire watch log that records work performed, start and end times, and any observations or incidents during the watch.

  7. An FDNY inspector arrives and asks the fire guard whether a hot work permit was obtained for the current torch operation. If no permit was obtained, the fire guard must:

    Answer: Immediately stop all torch operations until a proper permit is obtained

    All torch operations must cease immediately if a required hot work permit has not been obtained; work cannot continue until proper authorization is in place.