F60 Construction Site Fire Safety Questions and Answers

Question 1

A torch operation is planned in an area where a wooden partition is located 10 feet from the work. The partition cannot be relocated. What is the MINIMUM requirement before this work can begin?

Accepted Answer

The partition must be protected with a fire-resistant shield or welding blanket.

Answer

A single fire guard with two fire extinguishers must be present.

Answer

The torch operator must use a lower temperature flame to reduce spark production.

Answer

The work must be completed in 15-minute intervals with a cool-down period.

Question 2

In addition to a portable fire extinguisher and proper personal protective equipment, what essential piece of equipment must be readily available to an F-60 Fire Guard on a construction site?

Accepted Answer

A means of communication for contacting the fire department.

Answer

A copy of the building's most recent blueprints.

Answer

A comprehensive first-aid kit.

Answer

A multi-tool for adjusting torch equipment.

Question 3

Which of the following is a primary duty of the "Responsible Person" in charge of the hot work program on a construction site?

Accepted Answer

Authorizing and issuing hot work permits after verifying all safety conditions are met.

Answer

Personally performing the fire watch for every torch operation.

Answer

Training torch operators on how to use their specific equipment.

Answer

Notifying the building's insurance company before any hot work begins.

Question 4

A fire guard arrives at a designated hot work area and detects a strong odor of paint thinner, as a nearby room was recently painted. The torch operator is ready to begin work. What should be the fire guard's immediate action?

Accepted Answer

Prohibit the start of the torch operation until the vapors have dissipated and the area is confirmed to be safe.

Answer

Instruct the operator to work quickly to minimize exposure time.

Answer

Set up a fan to blow the vapors away from the immediate work area.

Answer

Proceed with the fire watch but keep two fire extinguishers ready.

Question 5

A hot work authorization permit is being reviewed by an FDNY inspector. Which of the following pieces of information is required to be documented on the permit?

Accepted Answer

The specific location and type of hot work being performed.

Answer

The serial number of the torch equipment being used.

Answer

The home address of the fire guard on duty.

Answer

The estimated cost of the overall construction project.

Question 6

A torch operation is taking place on a steel deck, and there are several small, unguarded openings in the floor within the 35-foot hot work area. Which of the following is an acceptable method for mitigating this hazard?

Accepted Answer

Tightly covering the openings with a fire-resistant tarpaulin or welding blanket.

Answer

Positioning a second fire guard on the floor below with a water hose.

Answer

Instructing the torch operator to carefully avoid directing sparks toward the openings.

Answer

Filling the openings with sand only after the hot work is complete for the day.