Fire Watch Procedures Flashcards
7 cards from real F60 practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Fire Watch Procedures flashcards as text
If torch operations must take place closer than the required clearance distance from combustibles, what must be done?
Answer: Use fire-resistant shields or blankets to protect the combustibles and wet them down if possible
When the required clearance cannot be achieved, fire-resistant barriers and wetting of combustibles are required to protect against ignition from sparks or radiant heat.
What should a fire guard do upon discovering that a sprinkler head that was shielded during torch operations has been left covered after work concluded?
Answer: Remove the shield immediately to restore the sprinkler system's fire protection
Sprinkler shields must be removed immediately after torch operations end to restore full automatic fire suppression capability in the area.
A fire guard is assigned for torch work on a floor with a suspended ceiling. After work ends, why is it especially important to check above the ceiling tiles?
Answer: Because sparks may have traveled above the tiles and ignited hidden combustibles
Sparks and heat can travel through ceiling openings and ignite hidden combustible materials above suspended ceilings, which are concealed from normal view.
Under what circumstance is a fire guard permitted to leave a fire watch post before the required watch period ends?
Answer: Only if relieved by another qualified, F-60 certified fire guard
A fire guard may only leave a post before the watch period ends when properly relieved by another person holding a valid F-60 certificate — there are no other acceptable exceptions.
During a fire watch on a high-rise building, fire is discovered and the fire guard calls 911. What additional action is required before the FDNY arrives?
Answer: Activate the building's fire alarm system and assist with occupant notification per the fire safety plan
Calling 911 is not sufficient alone — the fire guard must also activate the building fire alarm and follow the building's fire safety plan to notify and protect occupants.
After a rooftop torch job is complete and the fire guard's 30-minute post-work watch has ended, what final action must the fire guard perform before leaving?
Answer: Make a final inspection of the work area and all adjacent areas, document findings in the fire watch log, and confirm all hazards are clear
Before leaving, the fire guard must perform a final documented inspection, confirm no residual hazards remain, and complete the fire watch log to create a complete record.
Which scenario requires the fire guard to STOP torch operations immediately and refuse to allow them to resume?
Answer: The fire guard cannot maintain required line-of-sight to the work due to workspace configuration
Torch operations must stop if the fire guard cannot maintain direct line-of-sight observation, as effective fire watch coverage requires continuous visual monitoring of the work.