Safety Flashcards

Which type of fire extinguisher is appropriate for electrical equipment fires in a production facility?

Answer: Class C

Class C extinguishers are designed for energized electrical equipment fires because they use non-conductive agents.

What is the correct action when a machine guard is found to be damaged or missing during a pre-shift inspection?

Answer: Tag the machine out and report it before operating

A machine without proper guarding must be taken out of service and reported immediately to prevent injury.

A lockout/tagout procedure requires that after energy is isolated, what must the technician do before working on the equipment?

Answer: Attempt to restart the machine to confirm it is de-energized

After applying locks and tags, the technician must attempt to start the machine to verify all energy sources have been properly isolated.

In a manufacturing facility, what is the primary purpose of a safety data sheet (SDS)?

Answer: To provide hazard and safe handling information for chemicals

An SDS provides detailed information about chemical hazards, safe handling, storage, and emergency response procedures.

Which condition would most likely create a slip hazard in a production area?

Answer: Hydraulic fluid spilled on the floor

Hydraulic fluid creates a slippery surface that significantly increases the risk of falls, which are a leading cause of workplace injuries.

When working near overhead crane operations, production technicians should:

Answer: Maintain a safe distance and never walk under suspended loads

OSHA standards prohibit standing under suspended loads because dropped loads can cause fatal crush injuries.

What is the purpose of a Job Safety Analysis (JSA)?

Answer: To identify hazards and safe procedures for each step of a job

A JSA breaks a job into steps, identifies hazards at each step, and recommends controls to reduce the risk of injury.