Practice Test GeeksCPSI - Certified Playground Safety Inspector Practice Test
← All CPSI Flashcard Decks

Layout and Site Design Requirements (Use Zones) Flashcards

7 cards from real CPSI practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Layout and Site Design Requirements (Use Zones) flashcards as text

  1. When two swings are installed side-by-side on the same structure, how should the use zones be treated?

    Answer: The use zones may overlap only between the two swings but not with other equipment

    Use zones for swings on the same structure may overlap with each other but must not overlap with use zones of other equipment or structures.

  2. A merry-go-round has a diameter of 8 feet. What is the minimum required use zone radius measured from the outer edge of the equipment?

    Answer: 6 feet

    For rotating equipment like merry-go-rounds, CPSC guidelines require a minimum use zone of 6 feet beyond the perimeter of the equipment.

  3. A composite play structure has multiple elevated exit points at varying heights. Which height is used to calculate the required use zone?

    Answer: The height of the highest designated play surface

    The use zone for a composite structure is based on the height of the highest designated play surface, ensuring adequate fall protection for the worst-case fall.

  4. What is the minimum use zone required in front of and behind a belt swing with a pivot point 8 feet high?

    Answer: Twice the height of the pivot point (16 feet) in front and behind

    For swings, the use zone in front and behind equals twice the height of the pivot point, so an 8-foot pivot requires 16 feet of clearance in those directions.

  5. A slide structure's use zone at the exit must extend at least how far beyond the end of the slide chute?

    Answer: 6 feet

    CPSC guidelines require the use zone at the slide exit to extend at least 6 feet beyond the end of the slide chute to accommodate children's exit trajectory.

  6. Two adjacent pieces of equipment have use zones that overlap. Which of the following is the correct remedy?

    Answer: Reposition one or both pieces of equipment to eliminate the overlap

    The correct remedy for overlapping use zones between separate pieces of equipment is to reposition the equipment so the zones no longer overlap.

  7. What is the minimum side use zone (lateral clearance) required for a single-axis swing measured from directly under the pivot point?

    Answer: 4 feet

    CPSC guidelines specify a minimum lateral (side) use zone of 4 feet from directly below the pivot point for single-axis swings.