Practice Test GeeksCPSI - Certified Playground Safety Inspector Practice Test
← All CPSI Flashcard Decks

Specific Equipment Standards for Swings and Slides Flashcards

7 cards from real CPSI practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Specific Equipment Standards for Swings and Slides flashcards as text

  1. According to ASTM F1487, what is the minimum overhead clearance required above the highest designated play surface of a swing structure?

    Answer: 9 feet (2.74 m)

    ASTM F1487 requires a minimum of 9 feet (2.74 m) of overhead clearance above the highest designated play surface on swing structures.

  2. A 'tire swing' with a single-point suspension must have a use zone radius measured from what point?

    Answer: The center of the swing pivot point

    For single-point suspension tire swings, the use zone radius is measured from the center of the pivot point, extending at least 6 feet in all directions plus the length of the pendulum.

  3. Which condition on a slide chute surface requires immediate removal from service under CPSI guidelines?

    Answer: A crack or perforation in the sliding surface

    Any crack or perforation in a slide chute surface is a serious entrapment and injury hazard that requires immediate removal from service.

  4. What is the maximum allowable gap between the slide's exit edge and the ground for a slide intended for children under 5?

    Answer: 11 inches (27.9 cm)

    For slides intended for children under 5, the exit edge must be no more than 11 inches (27.9 cm) above the protective surfacing.

  5. On a belt swing intended for school-age children, the minimum seat width specified by ASTM F1487 is:

    Answer: 8 inches (20.3 cm)

    ASTM F1487 specifies that belt swing seats for school-age children must be at least 8 inches (20.3 cm) wide.

  6. A composite slide with a curved transition from the slide to the exit region must maintain what minimum radius of curvature at the curve?

    Answer: At least 20 inches (50.8 cm)

    ASTM F1487 requires curves and transitions on slides to have a minimum radius of curvature of at least 20 inches (50.8 cm) to prevent abrupt changes that could cause ejection.

  7. When inspecting a swing set, which of the following hardware conditions is classified as a 'serious' hazard requiring immediate closure?

    Answer: S-hook opening greater than 0.04 inches (1 mm)

    An S-hook gap greater than 0.04 inches (1 mm) is a serious entrapment hazard because it can catch clothing, drawstrings, or body parts, requiring immediate closure.