Telescopic Handler Flashcards
6 cards from real CPCS practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 6 Telescopic Handler flashcards as text
What is the most common cause of telescopic handler overturning incidents on construction sites?
Answer: Exceeding the machine's safe working load at the operating radius
Overloading at extended radii is the leading cause of telehandler overturns. As the boom extends forward and upward, the machine's capacity decreases significantly. Operators must always refer to the load chart and never exceed the rated capacity at the working radius.
When should the stabilisers (outriggers) be deployed on a telescopic handler?
Answer: Whenever the machine is being used for lifting operations as specified in the manufacturer's instructions
Stabilisers must be deployed whenever the manufacturer's load chart requires them for the planned lifting operation. The load chart will specify different capacities with and without stabilisers. Operating without stabilisers when they are required dramatically reduces the machine's stability.
What type of CPCS card category covers the telescopic handler?
Answer: A17 — Telehandler
CPCS category A17 covers the telescopic handler (telehandler). Operators must hold a valid CPCS A17 card to demonstrate competence in operating this specific type of machine, which covers both lifting and load-carrying duties.
What is the correct procedure for picking up a pallet of bricks with a telehandler fitted with forks?
Answer: Approach slowly, insert forks fully under the load, tilt back slightly, then raise
The correct procedure is to approach the pallet slowly and squarely, insert the forks fully under the load to ensure even weight distribution, tilt the forks back slightly to secure the load against the carriage, then raise to the required travel height.
When travelling a loaded telehandler on site, how should the load be carried?
Answer: Low to the ground with the boom retracted and forks tilted slightly back
When travelling, the load should be carried as low as practicable (approximately 300-500mm above ground), with the boom fully retracted and the forks tilted slightly back. This keeps the centre of gravity low and maintains maximum machine stability.
What safety device prevents a telehandler from lifting beyond its rated capacity?
Answer: The load moment indicator (LMI) or rated capacity indicator
The load moment indicator (LMI) or rated capacity indicator monitors the load weight against the machine's capacity at the current boom extension and angle. It provides audible and visual warnings and can lock out boom functions if the rated capacity is approached or exceeded.