← All Civil Engineering PE Flashcard Decks

Water and Wastewater Treatment Flashcards

7 cards from real Civil Engineering PE practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Water and Wastewater Treatment flashcards as text
  1. A wastewater treatment plant has a BOD₅ of 200 mg/L and a flow of 2 MGD. What is the BOD load entering the plant in lb/day?

    Answer: 3,338 lb/day

    Load (lb/day) = concentration (mg/L) × flow (MGD) × 8.34 = 200 × 2 × 8.34 = 3,336 ≈ 3,338 lb/day.

  2. Which type of lagoon uses algae to supply oxygen to heterotrophic bacteria for BOD removal?

    Answer: Facultative lagoon

    Facultative lagoons have an aerobic upper zone where algae supply oxygen via photosynthesis and an anaerobic lower zone for sludge digestion.

  3. In a water softening process using lime-soda ash, what does the addition of soda ash (Na₂CO₃) primarily remove?

    Answer: Non-carbonate (permanent) hardness caused by calcium sulfate or chloride

    Soda ash supplies CO₃²⁻ to precipitate non-carbonate (permanent) hardness cations like Ca²⁺ associated with sulfate or chloride.

  4. What is the mean cell residence time (MCRT or SRT) if the aeration basin volume is 500,000 gallons, MLSS = 2,500 mg/L, daily sludge wasting = 5,000 lb/day, and effluent TSS is negligible?

    Answer: ~2.1 days

    Mass in basin = 500,000 gal × 2,500 mg/L × 8.34×10⁻⁶ lb·L/(mg·gal) ≈ 10,425 lb; SRT = 10,425/5,000 ≈ 2.1 days.

  5. Ultraviolet (UV) disinfection of wastewater is most effective at which UV wavelength range?

    Answer: 254 nm (germicidal UV-C)

    UV-C at approximately 254 nm is most germicidal because it is absorbed by DNA, causing thymine dimer formation and inactivating microorganisms.

  6. In a trickling filter, the hydraulic application rate (HAR) is typically expressed in units of:

    Answer: million gallons per day per acre

    Hydraulic application rate for trickling filters is expressed as MGD/acre (or sometimes gpm/ft²), while organic loading is in lb BOD/1,000 ft³/day.

  7. Which parameter is used to measure the oxygen-depleting strength of industrial wastewater when biological methods are not applicable?

    Answer: Chemical oxygen demand (COD)

    COD uses a strong chemical oxidant (dichromate) to measure total oxidizable matter, including non-biodegradable compounds, making it suitable for toxic industrial wastewaters.