Drip and Micro-Irrigation Systems Flashcards
6 cards from real CIT practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 6 Drip and Micro-Irrigation Systems flashcards as text
What is the primary water-saving advantage of drip irrigation over sprinkler irrigation?
Answer: Water is applied at the root zone, reducing evaporation and wind drift
Drip irrigation delivers water directly to the root zone, significantly reducing losses from evaporation, wind drift, and surface runoff.
What is a pressure-compensating (PC) drip emitter?
Answer: An emitter that maintains a constant flow rate across a range of inlet pressures
Pressure-compensating emitters deliver consistent flow rates (e.g., 1 GPH) across a wide pressure range, typically 15–45 PSI.
What is the typical operating pressure range for drip irrigation systems?
Answer: 15–30 PSI
Drip irrigation systems operate at 15–30 PSI, far lower than sprinkler systems, to deliver water slowly through small emitter orifices.
What minimum mesh size filter is recommended upstream of drip emitters?
Answer: 120-mesh
A minimum 120-mesh filter is recommended for drip emitters to capture fine particles that would clog the small emitter orifices.
What is the purpose of a pressure regulator installed in a drip irrigation zone?
Answer: Reduce and stabilize pressure to protect drip tubing and emitters
A pressure regulator reduces incoming supply pressure to the correct operating range (15–30 PSI) to protect drip components from damage.
What material is the flexible black mainline and lateral tubing used in most drip systems made of?
Answer: Polyethylene (poly) tubing
Polyethylene (poly) tubing is the flexible plastic piping used as mainline and lateral distribution lines in drip irrigation systems.