Practice Test GeeksCHST - Construction Health and Safety Technician Practice Test
← All CHST Flashcard Decks

Fall Protection and Prevention Flashcards

6 cards from real CHST practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 6 Fall Protection and Prevention flashcards as text

  1. Under OSHA 1926.502(b), what is the minimum load-bearing capacity required for the top rail of a guardrail system on construction sites?

    Answer: 200 lbs applied in any outward or downward direction

    OSHA 1926.502(b)(3) requires that top rails of guardrail systems be capable of withstanding a force of at least 200 lbs applied in any outward or downward direction at any point along the top edge.

  2. What is the required height range for a standard guardrail top rail on a construction site per OSHA 1926.502?

    Answer: Between 39 and 45 inches

    OSHA 1926.502(b)(1) specifies that top rails must be installed between 39 and 45 inches above the walking/working surface to properly protect workers from falls.

  3. A safety net system must be installed no more than how many feet below the working surface per OSHA 1926.502(c)?

    Answer: 30 feet

    OSHA 1926.502(c)(1) requires safety nets to be installed as close as practicable to the working surface but no more than 30 feet below to limit fall distance and ensure effective arrest.

  4. Which type of lanyard is designed to reduce peak fall arrest forces by absorbing energy during its deployment?

    Answer: Shock-absorbing lanyard

    Shock-absorbing lanyards contain a tear-web or similar device that rips open during a fall, dissipating energy and reducing the peak arresting force transmitted to the worker's body.

  5. Under OSHA 1926.502(b), what is required between the top rail and the walking surface of a guardrail system when there is no wall or parapet wall at least 21 inches high?

    Answer: A midrail, screen, mesh, or other intermediate member installed midway between the top rail and the walking surface

    OSHA 1926.502(b)(2) requires that a midrail, screen, mesh, or other intermediate member be installed approximately midway between the top rail and the walking/working surface when there is no wall or parapet at least 21 inches high.

  6. Under OSHA 1926.502, when using a personal fall arrest system, what is the maximum arresting force that may be applied to a worker during a fall?

    Answer: 1,800 lbs

    OSHA 1926.502(d)(16)(ii) limits the maximum arresting force on a worker to 1,800 lbs when a body harness is used, to reduce the risk of injury during fall arrest.