CFP CFP Tools, Equipment & Maintenance

Question 1

Which type of post driver is most commonly used for installing T-posts quickly in agricultural or temporary fence applications?

Accepted Answer

Manual driver (handheld slide hammer)

Answer

Hydraulic post pounder

Answer

Pneumatic nail gun

Answer

Rotary hammer drill

Question 2

What is the correct method to prevent rust on cut chain-link wire ends after installation?

Accepted Answer

Bend the cut wire ends inward or cap them

Answer

Apply a coat of paint immediately

Answer

Leave them exposed; galvanized wire is self-protecting

Answer

Apply silicone sealant to each cut end

Question 3

Which power tool is typically used to drive concrete anchor bolts into a cured concrete footing for fence post attachment?

Accepted Answer

Rotary hammer drill with masonry bit

Answer

Reciprocating saw

Answer

Belt sander

Answer

Magnetic drill press

Question 4

A fence contractor's come-along (hand ratchet puller) is primarily used for which task?

Accepted Answer

Tensioning wire mesh or fabric against fence posts

Answer

Mixing concrete in tight spaces

Answer

Lifting heavy gate panels overhead

Answer

Driving wooden posts into rocky soil

Question 5

What is the recommended practice for maintaining hydraulic post hole digger (auger) equipment?

Accepted Answer

Check hydraulic fluid level and condition regularly and replace worn auger teeth

Answer

Drain all hydraulic fluid after each use

Answer

Run the engine at maximum RPM to burn off debris

Answer

Store augers in water to prevent rust

Question 6

Which measuring tool is used to ensure a fence post is perfectly vertical (plumb)?

Accepted Answer

Spirit level (bubble level)

Answer

Tape measure

Answer

Transit level

Answer

Steel square