HVAC Systems & Leak Detection Flashcards
7 cards from real CFC practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 HVAC Systems & Leak Detection flashcards as text
Which condition indicates that an electronic refrigerant leak detector's sensor needs replacement or recalibration?
Answer: All of the above may indicate sensor problems
Both false alarms and failure to detect known leaks indicate a sensor that is degraded, contaminated, or out of calibration and needs service.
What is the primary reason that nitrogen, rather than air, is used to pressurize HVAC systems during leak testing?
Answer: Nitrogen is dry and inert, preventing moisture and combustion risk
Dry nitrogen is moisture-free and chemically inert, preventing contamination of the refrigerant circuit and eliminating combustion or oxidation risks.
A rooftop unit's subcooling measurement is significantly lower than the manufacturer's specification. What does this most likely indicate?
Answer: System is undercharged, consistent with a leak
Low subcooling indicates insufficient liquid refrigerant in the condenser, a typical symptom of a refrigerant undercharge caused by a leak.
Under EPA Section 608, how soon must an owner or operator repair a leaking appliance that exceeds the applicable leak rate threshold?
Answer: Within 30 days of discovery
EPA Section 608 requires that equipment exceeding the applicable leak rate be repaired within 30 days of identifying the leak.
Which factor most directly accelerates corrosion-related refrigerant leaks in copper tubing used in coastal HVAC installations?
Answer: Salt air causing copper pitting and pinhole leaks
Salt-laden air in coastal environments causes aggressive electrochemical pitting of copper refrigerant tubing, leading to pinhole leaks.
What refrigerant management practice is required by EPA regulations when a technician recovers refrigerant from a leaking system before making repairs?
Answer: The refrigerant must be stored in approved containers and either reused, recycled, or reclaimed
Recovered refrigerant must be stored in approved DOT containers and can be reused in the same system, recycled on-site, or sent to a certified reclaimer.
A technician performing a bubble test applies soap solution to brazed fittings under system pressure and observes no bubbles. What can be concluded?
Answer: No leak exists at the tested fittings under current pressure conditions
A negative bubble test only confirms no detectable leak at the specific fittings tested under current pressure; other locations or leak rates below bubble test sensitivity are unconfirmed.