Practice Test Geeks(CCS) Certified Customs Specialist Practice Test
← All CCS Flashcard Decks

Quality Control & Inspection Flashcards

7 cards from real CCS practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Quality Control & Inspection flashcards as text

  1. Which document establishes the minimum acceptable quality level (AQL) for a specific material or product on a construction project?

    Answer: Project specification

    Project specifications define the required quality standards, including AQLs, for materials and workmanship.

  2. A Special Inspector discovers a structural weld that does not conform to AWS D1.1 during construction. What is the FIRST action the inspector should take?

    Answer: Issue a nonconformance report to the contractor

    The first step is to document the deficiency with a nonconformance report so the contractor is formally notified.

  3. What is the primary purpose of a mock-up in construction quality control?

    Answer: To establish a benchmark for workmanship and appearance

    Mock-ups create an approved reference standard against which installed work is compared throughout the project.

  4. Under the IBC, which party is responsible for engaging the Special Inspector?

    Answer: Owner or the registered design professional in responsible charge

    IBC Section 1705 places the responsibility for employing Special Inspectors on the owner or the design professional in responsible charge.

  5. Which type of testing involves evaluating a material sample destructively to verify compliance with specification requirements?

    Answer: Acceptance testing

    Acceptance testing often involves destructive methods (e.g., concrete cylinder breaks) to confirm material properties meet specifications.

  6. A Certified Construction Specifier (CCS) is reviewing a quality control plan. Which element is MOST critical to include?

    Answer: Inspection and test plan (ITP) with hold points

    An Inspection and Test Plan with defined hold and witness points is the cornerstone of any formal quality control plan.

  7. What does a 'hold point' in an Inspection and Test Plan (ITP) signify?

    Answer: Work must stop until inspection is performed and approved

    A hold point mandates that work cannot proceed past that stage until the designated inspector has reviewed and approved the work.