Practice Test Geeks(CCS) Certified Construction Specifier Practice Test
← All CCS Flashcard Decks

Codes, Standards & Regulatory Compliance Flashcards

7 cards from real CCS practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Codes, Standards & Regulatory Compliance flashcards as text

  1. Which federal regulation requires construction sites disturbing one or more acres to obtain a National Pollutant Discharge Elimination System (NPDES) permit?

    Answer: EPA Clean Water Act Section 402

    The EPA's NPDES stormwater construction general permit, authorized under Clean Water Act Section 402, applies to sites disturbing one or more acres of land.

  2. A specification requires materials to comply with 'applicable codes.' What is the specifier's best practice to make this requirement enforceable?

    Answer: List specific code editions and sections that apply to each material or system

    Specifying exact code editions and sections provides clear, enforceable compliance requirements and avoids ambiguity about which version applies.

  3. Which standard published by ASHRAE establishes minimum ventilation rates for acceptable indoor air quality?

    Answer: ASHRAE 62.1

    ASHRAE 62.1 (Ventilation and Acceptable Indoor Air Quality) sets minimum ventilation rates and other measures for commercial and institutional buildings.

  4. Under the National Historic Preservation Act (NHPA) Section 106, federal agencies must consider the effect of federally funded undertakings on properties listed on or eligible for the:

    Answer: National Register of Historic Places

    Section 106 of the NHPA requires federal agencies to consider effects of their undertakings on historic properties listed on or eligible for the National Register of Historic Places.

  5. Which IBC construction type designation describes a building where all structural elements are of noncombustible materials with the highest fire-resistance ratings?

    Answer: Type I-A

    IBC Type I-A construction requires all structural elements to be noncombustible and provides the highest fire-resistance ratings (3-hour columns, 2-hour floors).

  6. The Toxic Substances Control Act (TSCA) Section 6(h) restricts the use of which material in building products above specific concentration thresholds?

    Answer: Asbestos

    TSCA Section 6(h) addresses asbestos, and EPA has issued rules restricting ongoing uses of asbestos-containing products under this authority.

  7. When specifying glazing for hazardous locations as required by IBC Section 2406, which CPSC standard is referenced for safety glazing?

    Answer: CPSC 16 CFR 1201

    CPSC 16 CFR Part 1201 is the Consumer Product Safety Commission's Safety Standard for Architectural Glazing Materials, referenced by the IBC for hazardous locations.