Mechanical Engineering Flashcards
7 cards from real Building Engineering practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Mechanical Engineering flashcards as text
What is the primary purpose of a cooling tower in a building's HVAC system?
Answer: To reject heat from the condenser water loop to the atmosphere
Cooling towers dissipate heat from condenser water by evaporating a small portion of the water into the airstream, rejecting heat to the atmosphere.
Which pipe insulation parameter directly limits the rate of condensation on cold water lines?
Answer: Vapor retarder perm rating
A low-perm vapor retarder on insulation prevents moist air from migrating to the cold pipe surface where it would condense.
A VFD (Variable Frequency Drive) on a pump motor reduces the pump speed to 80% of design. By what factor does the pump's power consumption change according to the affinity laws?
Answer: 0.51 (cube reduction)
The affinity laws state that pump power varies as the cube of the speed ratio, so 0.8³ ≈ 0.51, meaning power drops to about 51% of design.
In a forced-air duct system, static regain design attempts to maintain constant what at each branch takeoff?
Answer: Total static pressure
Static regain design sizes downstream ducts so velocity reduction converts kinetic energy back to static pressure, keeping static pressure roughly equal at each takeoff.
What ASHRAE standard primarily governs acceptable indoor air quality and minimum ventilation rates for commercial buildings?
Answer: ASHRAE 62.1
ASHRAE 62.1 sets minimum ventilation rates and IAQ requirements for commercial and institutional buildings.
Which type of heat exchanger configuration achieves the highest thermal effectiveness for a given surface area?
Answer: Counter-flow
Counter-flow heat exchangers allow the outlet temperature of one fluid to approach the inlet temperature of the other, maximizing the mean temperature difference and effectiveness.
A building's mechanical room requires adequate clearance around equipment primarily to comply with which requirement?
Answer: Equipment manufacturer service access and ASHRAE 15 refrigerant leak egress
Mechanical room clearances are driven by manufacturer minimum service clearances and ASHRAE 15 requirements for safe egress in case of refrigerant release.