Practice Test Geeks(ATT) ACI Aggregate Testing Technician Practice Test
← All ATT Flashcard Decks

Moisture Content & Specific Gravity Flashcards

7 cards from real ATT practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Moisture Content & Specific Gravity flashcards as text

  1. An aggregate is described as 'oven-dry.' Which statement best describes this condition?

    Answer: All evaporable moisture removed by heating to 110 ± 5°C

    Oven-dry (OD) condition means all evaporable water has been removed by drying at 110 ± 5°C to constant mass per ASTM C566.

  2. The Le Chatelier flask method is an alternative procedure for determining specific gravity of which material?

    Answer: Fine aggregate passing the No. 4 sieve

    The Le Chatelier flask (volumetric flask) method can be used for fine aggregate specific gravity as an alternative to the pycnometer method.

  3. During the SSD cone test for fine aggregate, a properly SSD sample will:

    Answer: Slump and lose its molded shape when the cone is lifted

    At SSD, the fine aggregate cone slumps slightly when the mold is removed, indicating surface moisture is absent while internal pores are saturated.

  4. When computing the mix design batch weights, a technician must adjust aggregate quantities because stockpile moisture differs from SSD. Which quantity is adjusted upward when aggregates are wetter than SSD?

    Answer: Aggregate batch weight is increased; mix water is decreased

    Wet aggregates carry extra water, so aggregate batch weight increases to maintain the target SSD weight, and mix water addition decreases by the same free moisture amount.

  5. What is 'absorption capacity' of an aggregate as defined by ASTM?

    Answer: The percentage of water the aggregate will absorb to reach SSD from oven-dry

    Absorption is the increase in mass of oven-dry aggregate after soaking in water to reach SSD, expressed as a percentage of the OD mass.

  6. A coarse aggregate sample has an OD mass of 4,850 g and an SSD mass of 4,970 g. What is its absorption?

    Answer: 2.47%

    Absorption = (4970 − 4850) / 4850 × 100 = 120 / 4850 × 100 ≈ 2.47%.

  7. Why is it important to remove entrapped air bubbles from the pycnometer during fine aggregate specific gravity testing?

    Answer: Trapped air inflates the measured water volume, causing an artificially low specific gravity result

    Air bubbles occupy volume in the pycnometer and are counted as water, making the displaced water volume appear larger and yielding a falsely low specific gravity.