Paintless Dent Repair Tools 2 — Questions and Answers
Question 1: What is the primary purpose of a PDR slide hammer with glue tabs?
- To pull dents outward when there is no rear access (Correct answer)
- To sand down high spots
- To repaint the repaired area
- To heat the panel before pushing
Correct answer: To pull dents outward when there is no rear access
Glue pulling with a slide hammer or tab puller lifts dents from the outside when the panel's backside is inaccessible.
Question 2: Which tool is used to gently tap down small high spots left after pushing a dent?
- Blending hammer (knockdown) with a tap-down tip (Correct answer)
- Angle grinder
- Heat gun
- Glue gun
Correct answer: Blending hammer (knockdown) with a tap-down tip
A blending hammer or knockdown is tapped over a tip to lower high spots flush with the surrounding metal.
Question 3: A PDR reflection board (line board) is mainly used to do what?
- Read the dent's depth and shape through light reflection (Correct answer)
- Apply adhesive evenly
- Cool the panel quickly
- Measure paint thickness
Correct answer: Read the dent's depth and shape through light reflection
Line boards cast lines across the panel so the technician can see distortions and track the rod tip.
Question 4: Why are interchangeable rod tips important in a PDR rod set?
- Different tip shapes match different dent contours and access points (Correct answer)
- They make rods lighter
- They prevent rust on the rod
- They are only decorative
Correct answer: Different tip shapes match different dent contours and access points
Swappable tips let one rod address varied dent shapes and panel curvatures.
Question 5: What does a PDR tap-down pen typically have on its tip?
- A hardened nylon or plastic point to avoid marring paint (Correct answer)
- A steel spike
- A sandpaper pad
- A magnet
Correct answer: A hardened nylon or plastic point to avoid marring paint
Nylon or plastic tips knock down high spots without chipping or scratching the finish.
Question 6: Which tool helps a technician access a dent inside a door panel?
- A long thin door rod or whale tail (Correct answer)
- A bench vise
- A floor jack
- A torque wrench
Correct answer: A long thin door rod or whale tail
Slim door tools and whale tails slip between the window seal and inner skin to reach the dent.
Question 7: What is the function of a wedge or air bladder in PDR work?
- To create a small gap for inserting tools without damaging panels (Correct answer)
- To inflate tires
- To clean glue residue
- To polish the paint
Correct answer: To create a small gap for inserting tools without damaging panels
Wedges and air bladders gently pry an opening so rods can be inserted safely.
Paintless Dent Repair Tools 2
What is the primary purpose of a PDR slide hammer with glue tabs?