Forklift certification Certification Forklift certification Workplace Hazard Identification 2 — Questions and Answers
Question 1: A pedestrian walkway crosses a forklift travel aisle with no markings. What is the correct hazard control?
- Install painted floor lines, signage, and ideally a physical barrier (Correct answer)
- Ask pedestrians to look before crossing
- Increase forklift speed to clear the area faster
- Do nothing since drivers are trained
Correct answer: Install painted floor lines, signage, and ideally a physical barrier
Separating pedestrians from forklift traffic with markings, signs, and barriers is the primary engineering control for this hazard.
Question 2: You notice a hydraulic fluid leak spreading under a parked forklift. What hazard does this create?
- Slip and fall plus fire hazard, and possible loss of lift function (Correct answer)
- Only a minor cosmetic issue
- Improved floor lubrication for pallet jacks
- No hazard if the forklift is off
Correct answer: Slip and fall plus fire hazard, and possible loss of lift function
Hydraulic leaks create slip, fire, and equipment-failure hazards and must be cleaned and reported immediately.
Question 3: Which condition most increases the risk of a forklift tip-over on a ramp?
- Traveling across the slope with a raised, heavy load (Correct answer)
- Traveling straight down with the load low
- Traveling up slowly with forks tilted back
- Parking at the bottom with brakes set
Correct answer: Traveling across the slope with a raised, heavy load
Turning or traveling across a slope with a raised load shifts the center of gravity outside the stability triangle, causing tip-overs.
Question 4: What is the main hazard of stacking a load higher than the load backrest allows?
- Items can fall backward onto the operator (Correct answer)
- The forklift uses less fuel
- The load becomes easier to see over
- Tires wear out faster
Correct answer: Items can fall backward onto the operator
Loads exceeding the backrest can topple back toward the operator, so height must stay within the backrest's protection.
Question 5: In a warehouse aisle, what does a blind intersection require the operator to do?
- Slow down, sound the horn, and stop if visibility is blocked (Correct answer)
- Speed up to clear it quickly
- Raise the forks for better sight lines
- Rely only on the reverse alarm
Correct answer: Slow down, sound the horn, and stop if visibility is blocked
Blind intersections demand slowing, honking, and yielding to avoid collisions with pedestrians or other equipment.
Question 6: Which of these is a struck-by hazard commonly linked to forklifts?
- Falling loads from overhead racking (Correct answer)
- Ergonomic strain from typing
- Poor indoor air quality from copiers
- Excessive computer screen glare
Correct answer: Falling loads from overhead racking
Loads falling from height or off the forks are classic struck-by hazards around forklift operations.
Question 7: What is the correct action when you identify a damaged floor grate in a travel path?
- Tag or barricade the area and report it before driving over it (Correct answer)
- Drive over it carefully at full speed
- Ignore it if the forklift is heavy enough
- Move the load by hand instead
Correct answer: Tag or barricade the area and report it before driving over it
Damaged flooring must be marked and reported to prevent tip-overs or wheel damage until it is repaired.
Forklift certification Certification Forklift certification Workplace Hazard Identification 2
A pedestrian walkway crosses a forklift travel aisle with no markings.
What is the correct hazard control?