Forklift certification Certification Forklift certification Safe Driving and Maneuvering 3 — Questions and Answers
Question 1: If a forklift starts to tip over, the operator should:
- Jump clear of the machine
- Stay in the seat, brace, and lean away from the fall (Correct answer)
- Grab the forks
- Stand up quickly
Correct answer: Stay in the seat, brace, and lean away from the fall
Stay seated, hold the wheel, brace your feet, and lean away from the point of impact rather than jumping.
Question 2: When traveling without a load, the forks should be:
- Raised to eye level
- Lowered about 4-6 inches off the floor and tilted back (Correct answer)
- Dragging on the ground
- Fully extended forward
Correct answer: Lowered about 4-6 inches off the floor and tilted back
Carry forks low, roughly 4-6 inches off the floor and tilted back, for stability and clearance.
Question 3: What should an operator do when approaching a blind intersection?
- Assume it is clear and proceed
- Stop, sound the horn, and look both ways (Correct answer)
- Accelerate through it
- Signal only with a hand
Correct answer: Stop, sound the horn, and look both ways
Stopping, honking, and checking both directions prevents collisions at blind corners.
Question 4: Why should you avoid sudden stops and sharp turns while carrying a load?
- It wastes fuel
- It can cause the load to shift or the truck to tip (Correct answer)
- It scratches the floor
- It is against warehouse etiquette only
Correct answer: It can cause the load to shift or the truck to tip
Abrupt maneuvers can destabilize the load or the truck, leading to tip-overs or dropped loads.
Question 5: On a wet or slippery floor, the operator should:
- Drive faster to get through it
- Reduce speed and increase stopping distance (Correct answer)
- Turn sharply to test traction
- Ignore it entirely
Correct answer: Reduce speed and increase stopping distance
Slippery surfaces require slower speeds and greater stopping distance to maintain control.
Question 6: What is the proper way to handle pedestrians who are in your path?
- Yield the right of way to them (Correct answer)
- Expect them to move for you
- Drive around them at speed
- Bump the horn once and continue
Correct answer: Yield the right of way to them
Pedestrians always have the right of way; the operator must yield and stop if needed.
Question 7: When should you not travel with the load elevated high?
- Only when parking
- During normal travel—keep loads low (Correct answer)
- When the aisle is wide
- Only outdoors
Correct answer: During normal travel—keep loads low
Traveling with a raised load raises the center of gravity and increases tip-over risk, so keep loads low.
Forklift certification Certification Forklift certification Safe Driving and Maneuvering 3
If a forklift starts to tip over, the operator should: