F60 Permits and Record Keeping 3 — Questions and Answers
Question 1: The fire watch log shows that combustible debris was identified but NOT removed before torch operations began. What does this indicate?
- Acceptable if the C of F holder was present
- A violation of Hot Work Permit conditions that could invalidate the permit (Correct answer)
- Normal practice if the debris is small
- Only a concern if FDNY is on site
Correct answer: A violation of Hot Work Permit conditions that could invalidate the permit
Failing to remove combustible debris before operations violates standard Hot Work Permit conditions and can expose all parties to liability.
Question 2: Which scenario requires the Fire Guard to note an entry in the fire watch log IMMEDIATELY?
- A brief pause in welding to change equipment
- Detection of smoke or smoldering material in the work area (Correct answer)
- A coworker taking a scheduled break
- The arrival of additional materials to the job site
Correct answer: Detection of smoke or smoldering material in the work area
Any detection of smoke or smoldering must be logged immediately as it represents a potential fire emergency requiring action.
Question 3: After a Hot Work Permit expires, can the same permit be extended to cover additional days of work?
- Yes, by having the C of F holder sign the back of the permit
- Yes, if FDNY approves via phone
- No, a new permit must be issued for each new work period (Correct answer)
- No, but operations may continue for up to 24 hours past expiration
Correct answer: No, a new permit must be issued for each new work period
Expired permits cannot be extended; a new Hot Work Permit must be issued for each authorized work period.
Question 4: What is the primary purpose of requiring a Fire Guard to sign the fire watch log?
- To prove the Fire Guard is literate
- To create an auditable record of accountability for safety compliance (Correct answer)
- To satisfy union contract requirements
- To authorize payment for services rendered
Correct answer: To create an auditable record of accountability for safety compliance
The Fire Guard's signature creates a legally accountable record confirming they were present and performed required safety duties.
Question 5: A contractor begins torch operations without posting the Hot Work Permit on site. What should the Fire Guard do?
- Allow work to continue since the permit exists
- Stop work immediately and require the permit be posted before resuming (Correct answer)
- Note the missing posting but continue work
- Report the issue only after the shift ends
Correct answer: Stop work immediately and require the permit be posted before resuming
The Hot Work Permit must be posted and visible on site during operations; work must halt until this requirement is met.
Question 6: Which of the following is a required element in a fire watch log entry when torch operations are underway?
- The cost of materials being installed
- The name and C of F number of the Fire Guard on duty (Correct answer)
- The names of all workers on the floor
- The model number of the torch being used
Correct answer: The name and C of F number of the Fire Guard on duty
The Fire Guard's name and C of F number are required to identify the qualified individual responsible for the watch.
Question 7: If operations move to a different floor than what is listed on the Hot Work Permit, what must happen?
- The C of F holder may verbally authorize the change
- Operations must stop and a new or amended permit must be obtained for the new location (Correct answer)
- The Fire Guard can update the permit by writing in the new floor number
- No action is needed if the building is the same
Correct answer: Operations must stop and a new or amended permit must be obtained for the new location
The specific work location is a required field on the permit; any change in location requires a new or formally amended permit.
F60 Permits and Record Keeping 3
The fire watch log shows that combustible debris was identified but NOT removed before torch operations began.
What does this indicate?