F-01 F-01 - F-01 Fireguard Hot Work Operations and Permits Questions and Answers 2 — Questions and Answers
Question 1: If a hot work permit has expired mid-day, what must the fireguard do?
- Allow work to continue until the end of the shift
- Halt hot work operations immediately until a new permit is obtained (Correct answer)
- Reduce the scope of work and continue
- Call FDNY for an oral extension
Correct answer: Halt hot work operations immediately until a new permit is obtained
An expired hot work permit invalidates authorization for the work; operations must stop immediately and a renewed permit must be secured before resuming.
Question 2: Which of the following is considered a hot work hazard in a building under construction?
- Wet concrete curing
- Grinding metal framing that produces sparks near wood subflooring (Correct answer)
- Painting interior walls
- Installing drywall panels
Correct answer: Grinding metal framing that produces sparks near wood subflooring
Grinding metal near wood subflooring produces sparks that can ignite the wood, making it a classic hot work hazard requiring a permit and fire watch.
Question 3: What should a fireguard do if they discover that fire watch was not maintained during hot work because of a personnel oversight?
- Document the lapse in the fire watch log and notify the supervisor immediately (Correct answer)
- Ignore it if no fire occurred
- Continue the fire watch without noting the gap
- Notify only the building owner at the end of the week
Correct answer: Document the lapse in the fire watch log and notify the supervisor immediately
Any gap in fire watch coverage must be documented in the log and reported to the supervisor immediately so corrective action can be taken.
Question 4: What type of fire extinguisher is most appropriate for a hot work area where metal cutting is performed?
- Class A (water-based)
- Class B or multi-purpose ABC dry chemical (Correct answer)
- Class D (combustible metals)
- Class K (cooking oils)
Correct answer: Class B or multi-purpose ABC dry chemical
A multi-purpose ABC dry chemical or CO₂ extinguisher is suitable for hot work areas because it handles fires involving ordinary combustibles and flammable liquids commonly present.
Question 5: A fireguard notices that the hot work area has poor ventilation causing heavy smoke buildup. What is the correct action?
- Continue work but open a nearby window
- Stop work, notify the supervisor, and ensure ventilation is improved before resuming (Correct answer)
- Use a fan to push smoke toward workers away from equipment
- Report the issue only at the end of the shift
Correct answer: Stop work, notify the supervisor, and ensure ventilation is improved before resuming
Poor ventilation creates toxic fume hazards and increases fire risk; work must stop and the condition must be corrected before operations resume.
Question 6: Hot work near sprinkler heads requires which special precaution?
- Removing the sprinkler heads entirely
- Covering sprinkler heads with approved heat-deflecting covers and removing covers immediately after work (Correct answer)
- Disabling the sprinkler system for the entire floor
- Applying tape over the sprinkler orifice
Correct answer: Covering sprinkler heads with approved heat-deflecting covers and removing covers immediately after work
Approved covers protect sprinkler heads from accidental activation by heat while still allowing them to function normally once covers are removed after hot work is done.
F-01 F-01 - F-01 Fireguard Hot Work Operations and Permits Questions and Answers 2
If a hot work permit has expired mid-day, what must the fireguard do?