CESCO - Certified Environmental, Safety and Compliance Officer Air Quality Regulations (CAA) Questions and Answers — Questions and Answers
Question 1: A chemical manufacturing facility is planning a major modification that will significantly increase its emissions of a regulated air pollutant. Under the Clean Air Act, which program directly requires this facility to obtain a permit before construction and install the Best Available Control Technology (BACT)?
- New Source Performance Standards (NSPS)
- National Emission Standards for Hazardous Air Pollutants (NESHAP)
- Title V Operating Permit Program
- New Source Review (NSR) (Correct answer)
Correct answer: New Source Review (NSR)
The New Source Review (NSR) program under the Clean Air Act requires new or modified major stationary sources of air pollution to obtain a permit before construction begins. This process ensures that facilities install modern pollution control equipment, such as the Best Available Control Technology (BACT), to minimize emissions increases.
Question 2: Which of the following are all considered 'criteria' air pollutants regulated under the National Ambient Air Quality Standards (NAAQS)?
- Ozone, Lead, Asbestos, and Carbon Monoxide
- Particulate Matter, Sulfur Dioxide, Mercury, and Nitrogen Dioxide
- Ground-level Ozone, Particulate Matter, Lead, and Sulfur Dioxide (Correct answer)
- Carbon Monoxide, Benzene, Lead, and Particulate Matter
Correct answer: Ground-level Ozone, Particulate Matter, Lead, and Sulfur Dioxide
The EPA has established National Ambient Air Quality Standards (NAAQS) for six principal pollutants known as 'criteria' pollutants: ground-level ozone, particulate matter (PM2.5 and PM10), lead, sulfur dioxide (SO2), nitrogen dioxide (NO2), and carbon monoxide (CO). These pollutants are widespread and can cause harm to public health and the environment.
Question 3: A facility has the potential to emit 12 tons per year of a single Hazardous Air Pollutant (HAP) and 28 tons per year of a combination of HAPs. According to the Clean Air Act, how would this facility be classified?
- An area source
- A minor source
- A major source (Correct answer)
- A synthetic minor source
Correct answer: A major source
Under the Clean Air Act, a major source is defined as a facility that has the potential to emit 10 tons per year or more of any single Hazardous Air Pollutant (HAP) or 25 tons per year or more of any combination of HAPs. Since this facility exceeds both thresholds, it is classified as a major source.
Question 4: The 1990 Clean Air Act Amendments introduced a cap-and-trade program primarily to address which environmental problem?
- Stratospheric ozone depletion
- Urban smog
- Hazardous air pollutant emissions
- Acid rain (Correct answer)
Correct answer: Acid rain
A key feature of the 1990 Clean Air Act Amendments was the establishment of the Acid Rain Program under Title IV. This program set a cap on total sulfur dioxide (SO2) emissions from power plants and created a market-based cap-and-trade system of allowances to reduce SO2 and nitrogen oxide (NOx) emissions, the primary precursors of acid rain.
Question 5: A new industrial facility is being built that falls into a source category for which the EPA has established specific, technology-based emission standards. Which Clean Air Act program sets these national, uniform standards for new and modified stationary sources?
- National Ambient Air Quality Standards (NAAQS)
- New Source Performance Standards (NSPS) (Correct answer)
- State Implementation Plans (SIPs)
- Maximum Achievable Control Technology (MACT)
Correct answer: New Source Performance Standards (NSPS)
New Source Performance Standards (NSPS) are technology-based standards issued by the EPA for specific categories of new, modified, and reconstructed stationary sources. These standards establish the minimum level of pollution control, known as the 'best demonstrated technology,' that must be achieved by facilities in that source category.
Question 6: What is the primary purpose of the Title V Operating Permit Program established by the Clean Air Act Amendments of 1990?
- To establish new, stricter emission limits for all major sources.
- To provide a framework for reducing mobile source emissions.
- To consolidate all applicable air quality regulations for a major source into a single, legally enforceable document. (Correct answer)
- To fund research into new pollution control technologies.
Correct answer: To consolidate all applicable air quality regulations for a major source into a single, legally enforceable document.
The Title V Operating Permit Program was created to consolidate all applicable federal, state, and local air quality requirements into a single permit document for major sources of air pollution. This clarifies a source's compliance obligations and enhances the ability of regulatory agencies to enforce the Clean Air Act. It does not, by itself, impose new substantive emission limits.
CESCO - Certified Environmental, Safety and Compliance Officer Air Quality Regulations (CAA) Questions and Answers
A chemical manufacturing facility is planning a major modification that will significantly increase its emissions of a regulated air pollutant.
Under the Clean Air Act, which program directly requires this facility to obtain a permit before construction and install the Best Available Control Technology (BACT)?